First of all, all places, even including the original car, the car is installed, the paint will not use what the "original paint!" If the repair shop to tell you that they are using the "original paint", it must be lying to you . The reason is very simple: When it comes to the original paint process, after spraying a good paint, baking temperature of 200 ℃. And so many components on the finished car, how many can withstand the temperature of 200 ℃? Is it then the car scrapped, leaving only the shell? Even if the manufacturer bumps rub is also used to repair the paint.

Fill paint with special repair paint. Repair paint baking temperature is relatively low, 60-80 ℃.

Second, the color of the refinish paint is reconciled before repairing. The reason is simple: Your car may have been around for years, and the paint has started to fade, though you can not tell. If you park outdoors, the degree of fading in different directions will be slightly different - the relationship between the sun's rays. To match as much as possible with the original color, only the current tune. Also, in order not to appear as much color as possible, even if you are not a big need to fill the paint, the factory will be the whole piece all the re-spray. For example, there is a place on the door that needs to be filled, so to prevent scratches, the upper half or the lower half is fully sprayed. In this way, if there is a small bit of color is not easy to see.

Also, if the time to buy a car for the beautiful, pearl paint to buy (good cars in China do not seem to have any car), paint the time, ready to cry. The directionality of the lacquered mica particles is hard, or almost impossible, to be the same. Paint even a little color does not complement the paint can also be a glance out.

Computer color spray in the spraying of the superb technology under the premise ("three-level" pearl paint to minor color difference seven or eight layers in the hands of spray workers) with the paint and the original color of the paint is out of the ordinary people's eyes . This point can rest assured. The key is: paint, equipment and people with responsibility.

There is no use of the original paint repair paint possible. However, under normal circumstances, the depot still recommends the designated refinish paint brand to the specialized service station. Good repair station will use good brand. However, in small shops, even less formal specialized service stations are likely to use cheaper lacquers for cost reduction (if not to say that they are fake). At that time may be the same effect, 3 months later, the color difference came. This, our users are almost impossible to identify. Only look for rest assured repair shop.

Although the repair paint baking temperature is relatively low, but does not mean that does not require baking or other alternative ways. If you find that the repair shop does not have a dedicated paint booth, use the "little sun" light to heat it. As early as possible for the place!

Also, the regular automobile factory production line, painting are carried out in the clean room. Although many purely made cars may not be so dry, but not equal to this does not need. If you see the garage is dirty, gray great. I suggest you change places for it. Many large repair shops, repair stations are equipped with dust-free dry grinding equipment, due to the use of dry grinding without water to avoid moisture because there is no complete evaporation spray paint caused blisters, rash, putty deformation, shedding and so on, even At that time look good, over time, the paint bubbles, shelling I have seen. Painting, we pay in addition, I am afraid we can only pay attention so much.